ASUS ROG Strix G16CH PC Turns On but No Display Output
Symptoms
- - Chassis fans spin up and motherboard RGB lights active, but monitor shows 'No Signal'
- - Loud repetitive beep codes sounding from the internal motherboard speaker
- - PC turns on for 3 seconds then automatically cycles off, creating an endless loop
Common Causes
- - RAM stick module resting loose or oxidation build-up on the gold contacts
- - GPU sag pulling the card out of the primary PCIe x16 slot contact points
- - Motherboard CMOS battery voltage dropping below operational limits (CR2032)
Step-by-Step Fix
Step-by-step diagnostic sequence to troubleshoot the POST process, re-seat memory slots, and restore display outputs on your ASUS ROG Strix G16CH.
Isolate System and Re-seat Memory RAM Modules
Unplug the AC power cord. Open the chassis side door panel. Press the release clips on the RAM slots, pull both memory sticks out completely, then rub the gold contacts gently with a clean eraser. Re-insert them firmly into slots 2 and 4 until you hear a solid click.
Never touch motherboard components while the main power supply remains plugged into wall outlets.
Reset Motherboard CMOS Battery
Locate the round silver CR2032 lithium battery on your motherboard. Use a flat precision screwdriver to gently depress the retaining tab. Pop the battery out, wait 5 minutes to fully drain capacitor charge, then click it back into place.
Problem discussions
Ask or answer in this exact problem context. The entity and problem are attached automatically so future AI summaries and guide updates use the right evidence.
Community signals will be summarized after discussions, replies, and accepted solutions are available.